Audio Solutions FLAGSHIP M, User Manual

Page: 18 / 26

Fig.2
OUTPUT CONNECTIONS
1 –
Speaker connections, minum load is 2 Ohm.
2 –
Female RCA connection for the input of the audio signal to be amplified, connect it to the car radio using a good
quality shielded cable to keep the best performance and to prevent noises.
3 –
Push-Button for setting the LCD display, refer to the appropriate section for the functions.
4 –
Potentiometer for set the sensivity.
Suggestions:
–
To tighten the screws of the terminal block do use a flat screwdriver of adequate size.
–
Do not use housings in the tip of the cables, the terminal block do properly accommodates all the cables, even
very thin ones.
–
Check the correct fixing of the cables once the terminal block have been tightened.
–
Fix the amplifier in the way you can access to the settings once installed.
–
Keep a space of at least 5cm at the sides, near the air holes, to allow the correct flow of air.
Audio Solution - Flagship user manual v.14
18
1 2 3 4