Audio Solutions FLAGSHIP M, User Manual

Page: 22 / 26

Diagnostics
Under normal conditions, when the amplifier is on, the blue LED on the power supply side and LCD display light up.
Each fault condition is displayed by the red LEDs on the power supply side and by the display
when the amplifier is switched on.
Below are the most common cases of failure and potential solutions.
PROBLEMA PROBABILE CAUSA
DISPLAY:
OVER C led turn on.
Check that there are no shorts on the speaker output and
that the load impedance is not under 2 Ohm.
Switch the amplifier off and on again, if the problem
persists contact the assistance.
DISPLAY:
OVER T e OVER C turn on.
The amplifier has exceeded the maximum operating
temperature, wait until the temperature drops and it will
be restored. If it happens too frequently, check the
installation and ensure better ventilation.
The amplifier does not switch on and the red "NO FUSE" LED
lights up.
Check the internal fuse (see the section below on this page "FUSE
inside").
FUSE inside:
The fuse is internal, if it is necessary to replace it, completely unplug the amplifier wait 10 minutes, remove the 4 screws
on the sides and lift the cover, replace the fuse only with one of the same type,
If the problem keep, contact the assistance.
SUGGESTION

If the fuse often burns out, check the amplifier load and speaker status.

If you just replace the fuse and it burns instantly, without turning on the amplifier, do not insist, bring the
device to an authorized center.

This amplifier has been designed to sound great and be performing, but not exaggerated with too heavy loads
(lower than those stated), even if the protections do not turn on, some anomalies can occur.
Audio Solution - Flagship user manual v.14
22
!!! WARNING !!!
OVER Temperature
!!! WARNING !!!
OVER CURRENT/DC