18
Power Output:
150 watts per channel continuous
from20Hz to 20kHz. 1kHz total
harmonic distortion typically 0.6% at
150 watts, below 0.03% at 1 watt.
Approximate actual power available
at ‘clipping’ 160 watts (1kHz). (Note
that actual power output is dependent
upon both line voltage and ‘condition’
i. e.: if power line has high distortion,
maximum power will be affected
adversely, although from a listening
standpoint this is not very critical)
Power Bandwidth:
(-3dB points)
5Hz to 80kHz
Frequency Response:
(-3dB points
at 1 watt) 0.5Hz to 120 kHz
Input Sensitivity:
2.0V RMS BAL for rated
output. (24 dB Bal gain into 8 ohms)
Input Impedance:
300K ohms Balanced
Output Polarity:
Non-inverting.
Balanced input pin 2+ (IEC-268)
Output Taps:
16 ohms, 8 ohms, 4 ohms
Output Regulation:
Approximately
0.6dB 16 ohm load to open circuit
(Damping factor approximately 14)
Overall Negative Feedback:
14dB
Slew Rate:
13 volts/microsecond
Rise Time:
2.0 microseconds
Hum & Noise:
Less than 0.1mV
RMS – 114dB below rated output
(IHF weighted, input shorted)
Power Supply Energy Storage:
Approximately 1040 joules.
Power Requirements:
105-
125VAC 60Hz (210-
250VAC 50Hz) 730 watts at rated output,
900 watts maximum, 420 watts idle
Tubes Required:
4 – Matched pair KT150
– Power Output; 4 – 6H30 Driver
Dimensions:
width:
19” (48.3 cm)
height:
8.75” (22.2 cm)
depth:
19.5” (49.5 cm)
Handles extend 1.5” (3.8 cm) forward
Weight:
75 lbs. (34.2 kg) Net
90 lbs. (41 kg) Shipping
Specifications
