PROCEDURE FOR:
REF75SE Update
PAGE: 9 of 11
ISSUED: 3/20/2015
4.5.
Input Wires and Panel
*Make sure the following wires are through the through hole before soldering and
when soldering use extreme caution not to melt and damage the wire insulation!
Repeat Steps 4.5.1 – 4.5.4 for each channel
4.5.1.
Solder 1 – 16 GA White Wire w/Sleeve from the update kit to the “+” location on the
main board.
4.5.2.
Solder 1 – 16 GA Clear Wire from the update kit to the Ground location on the main
board between the “+” and “-” locations.
4.5.3.
Solder 1 – 16 GA White Wire from the update kit to the “-” location on the main
board.
4.5.4.
Twist the 3 – Wires in 1-1/2
Counter Clockwise Rotations
(when standing at the
front of the unit)
and then place in the respective locations in the XLR Connectors
and solder.
Refer to Figure 21 to make sure the wires are in the correct orientation!
Figure 20
Figure 21
