AUDIO INTERNATIONAL, INC.
4/98
6
Document #540107, Rev. IR, Model No.: RCD-02201-x
2.0 Installation
2.1
Prior to Installation
The RCD is a simple AM-FM compact disc player to use and install. The RCD is
capable of accepting infrared digital input and/or RS-485 two-wire digital data
bus input. All audio input and output cables on the unit should be twisted
shielded pair (24 AWG minimum) unless otherwise specified. The unit must be
attached to conform to the standards designated by the customer, installing
agency, and existing conditions as to the unit location and type of installation.
The following should be carefully considered before installation:
2.1.1 Select a mounting location for the unit where 28 VDC power and audio
signal has been previously installed. Long low-level audio runs may
introduce noise into the audio signal. Refer to Section 5.0 Specifications
and Drawings for location of mounting points.
2.1.2 Locate the unit to allow easy audio level adjustments. Level adjustment
controls are located on the rear of the unit. These adjustment level
controls must be accessible for periodic system adjustments.
2.1.3 All headphone amplifiers and line level amplifiers should be located no
more than three feet away from source equipment.
2.1.4 Avoid installing the unit where it will be exposed to excessive heat,
excessive moisture, splashing liquids, dusty areas, direct sunlight, or
angled/inclined installations.
2.1.5 A minimum of 5.0 inch clearance is required in front of the CD slot.
When the CD is ejected, it will project approximately 2.25 inches.
2.2
Unpacking & Inspection
2.2.1 Carefully open the packaging and remove the compact disc player / AM-
FM Tuner. Verify that all components have been included in the package
per the packing list. Inspect the unit for damage. Retain the packing
materials and packing list. The components should arrive in good
condition.
If damage has occurred during shipping, a claim must be filed with AI
within 24 hours and a “Return Request Authorization Number” must be
obtained from AI. Refer to the front cover of this manual for address and
telephone number of Audio International, Inc. Repackage the unit in its
original packaging materials and return it to AI following instructions
given by the AI representative. If no return is necessary, retain the
packing materials for storage or reshipment if necessary.
