DVD-401-01-x Installation & Operation Manual
Document # 540254, Rev IR, 10/2002
Page 8 of 18
3.0
Cautions & Warnings
3.1 It is important to do a pin-to-pin power and ground check on all
connectors. Ensure that power and ground are applied only where
specified. Damage to the unit may result if power or ground is applied to
the wrong points.
3.2
DO NOT connect or disconnect the unit while power is applied.
3.3
DO NOT remove any factory-installed screws. Damage to the unit may
result and void any warranties.
3.4
DO NOT drop the unit or subject it to strong shock. The unit contains
glass parts that may break or crack.
3.5
DO NOT place foreign objects into openings. Contact with foreign objects
may result in dangerous voltage or electric shock.
3.6
DO NOT place near strong magnetic fields, radiators or other heat
sources.
3.7
DO NOT use this unit other than for its intended purpose. Doing so might
lead to electric shock or injury.
3.8
DO NOT use near water, moisture, or volatile sprays. Do not use any type
of solvent when cleaning (surface damage may occur).
3.9
DO NOT look directly into the laser beam through the disc tray opening.
Eyesight may be damaged.
3.10 DO NOT place fingers in disc tray when the tray is moving. Tray may
close on fingers and may cause injury.
3.11 DO NOT expose unit to sun or bright light. Damage to the sensor will
result.
3.12 NO scheduled maintenance is required to ensure continued airworthiness.
3.13 ESD (Electro Static Discharge) guidelines shall be followed.
