Audio Innovate AEM-100i, User Manual

Page: 16 / 16

16
TECHNICAL SPECIFICATIONS:
Inputs:
Line/Aux: 10k
Ω
input impedance, 5.6mV rms sensitivity for 1.0V output
Mic: 10k
Ω
input impedance, 1mV rms sensitivity for 1.0V output
Phono: 47k
Ω
input impedance, 0.9mV rms sensitivity @ 1kHz for 1.0V output
Outputs:
Master: 8.6V rms Booth: 8.6V rms
Record: 1.0V rms Headphone Amp: .5 watts / 47
Ω
, THD < 0.1%
Equalizer:
3-band Stereo Equalizer per channel, -30dB cut / +10dB boost
Signal to noise ratio
Line: 92dB (JIS-A) Aux: 92dB (JIS-A)
Mic: 87dB (JIS-A) Phono: 83dB (JIS-A)
Frequency Response
Line: 20Hz~20kHz 1dB Aux: 20Hz~20kHz 1dB
Mic: 20Hz~15kHz 1dB Phono: RIAA 0.5dB
Talkover attenuation: Maximum –19dB, minimum –16dB attenuation of main audio
Power consumption: 18 Watts typical, 22 Watts with full headphone output
Dimensions: 10” wide * 14” deep * 4.2” high
Weight: 6.0kg
Life rating:
Crossfader: >4,000,000 cycles CH1, CH2 Line faders: >100,000 cycles
Misc. faders: >100,000 cycles
Effect circuitry:
Noise, Oscilattor: 0 to 3dB max level, oscillator has variable frequency square wave.
Stutter: variable on/off from a few 1/10ths of a second transforms to high pitched ringing.
Digitize: variable frequency sample/hold circuit.
Phaser: dual phaser with variable cutoff.
Band Pass, Band Reject filters: 4-pole sweepable butterworth filters.
Fader/Crossfader section circuitry:
Minimum slope has cut-in of 1mm or less at the lowest audio position.
Average slope uses 0.2dB typical fader resolution
Maximum slope has cut-in of 1mm or less at the highest audio position.
Maximum delay on VCA fader controls = 1.64msec.
***VCA circuit has no delay in the audio path, delay is for the audio control only.