THUNDER
350 RGB
USER´S
MANUAL
Table Of Contents
1. Safety instruction
2. Introduction
3. Fixture overview
4. How to set the unit
4.1 Control panel
4.2 Main function
5. Control by DMX
5.1 DMX512 connection
5.2 Addressing setting
5.3 DMX protocol
6. Maintenance
6.1 Cleaning
6.2 LED performance
7. Technical Specification
13
MAINTENANCE
Following are a few common problems that may occur during
operation. Here
are some suggestions for easy troubleshooting:
A. The unit does not work, no light and the fan does not work
1. Check the connection of power and main fuse.
2. Measure the mains voltage on the main connector.
3. Check the power on LED.
B. Not responding to DMX controller
1. DMX LED should be on. If not, check DMX connectors and cables
to see if link properly.
2. If the DMX LED is on and no response to the channel, check the
address settings and DMX polarity.
3. If you have intermittent DMX signal problems, check the pins on
connectors or on PCB of the unit or the previous one.
4. Try to use another DMX controller.
5. Check if the DMX cables run near or run alongside to high voltage
cables that may cause damage or interference to DMX interface
circuit.
C. One of the channels is not working well
1. The stepper motor might be damaged or the cable connected to
the PCB is broken.
TECHNICAL SPECIFICATION
Control mode: DMX 512/Manual/Master&Slave
DMX Channel:5/13/54CH
Lighting source: 864pcs 0.4W RGB 3 in 1 LEDs
Power:350W
Beam angle:120 degree
Color system: RGB mixing color
Control Panel:LCD d Button
Flashing Rate: reaching at 10KHz PWM rating.
0-100% smooth linear dimming,20 kinds of internal programs
Dimension:460*124*230mm
Weight:4.3Kg
