AUDAC VIRO5, User Manual

Page: 10 / 12

VIRO5 - User manual 010
Chapter 4
Chapter 3
Connecting VIROs
Bracket
198,00
110,00
R5,50
R2
,50
40,00
70,00
The bracket of the VIRO is attached to the centre point of the speaker. It is designed in such a way that it can be fully rotated
around the centre point. This allows the bracket to be mounted in all directions, on the ceiling, wall or floor. As a result, VIRO
can be attached to various accessories.
For a solid fixation of the loudspeaker, it should always be attached by at least two screws. The position of the fastening
holes depends on the surface to be mounted. Always use the proper fasteners depending of the mounting surface. Once
the bracket is mounted on the desired location, the loudspeaker can be fixed to the bracket.
Multiple VIROs can be connected to each other. Make sure that all devices are switched off.
Connect the amplifier to the far left +/- of the 4-pin terminal block. The right-hand +/- at the terminal block is the connection
to the next VIRO. If the optional transformer module is installed, the linktrough must be done at the primary side of the
transformer.
- - + +