5
Step 6:
Assemble the display unit in the front panel of the M2/R2, at the location where
the dummy-plate was placed. Place and tighten the four screws again. Ensure the
screws are not over tightened, as this can prevent the unit from working!
Step 7:
Assemble the USB board back at the provided location on front of the device. Place
and tighten the two screws again, and make sure the USB unit is properly secured to
the front panel. Again, take care not to damage the pinheaders while tightening the
screws. (See step 3 of this manual)
