AUDAC PRE116, User Manual

Page: 11 / 16

11
3.5 mm Jack input (CH4):
A 3.5 mm jack input connection is provided on the front panel of the unit besides the channel
4 mixing control. This input is an unbalanced stereo line input, mixed with the rear panel
input of channel 4. Any portable device (such as laptop, smartphone or tablet) with 3.5 mm
jack audio output can be connected to this easy accessible input.
Output master control:
Each output section (only one for PRE116) contains a master volume control, two band tone
control and 6-segment VU LED bar. The master volume control allows regulation of the
overall output level, while two-band tone control allows bass / treble adjustment within a
range of ± 15 dB and the VU LED bar indicates of the overall output level.
Power switch:
Allows to power the system ON and OFF. The blue indicator LED illuminates when switched on.
Rear panel overview
Rear panel description
AC Power inlet with fuse:
The mains power supply (100-240V AC - 50/60 Hz) has to be applied to this AC power
inlet. The connection is made by an IEC C14 power connector and is fitted with a fuse. When
replacing the fuse, make sure that the value of the replacement fuse matches the value of
the original fuse. (T500mAL/250V)
Balanced stereo line output:
The balanced stereo line output(s) is implemented using two 3-pin terminal block output
connectors. The audio signal available on these connectors allows it to be fed to any amplifier.
A mode switch allows to convert the output between stereo and mono. In mono mode, a
summed mono signal will be available on both left & right outputs, allowing the signal be
fed to mono systems such as 100V PA systems.