12
2)
Bridge mono Mode:
When the amplifier is switched in bridge mode, there will be one single load
connected to the amplifier outputs. This load should be connected between the +
terminal of the Left channel and the – terminal of the Right channel.
3)
Parallel Mode:
When the amplifier is switched in parallel mode, the connections for the
loudspeakers should be made in the same way as Stereo mode.
Note
Do not connect any 100V line transformers to the loudspeaker outputs of the amplifier.
The minimum load for the subwoofer channel is 8 Ohm.
Connection standards
The in- and output connections of AUDAC audio equipment are performed corresponding to
international wiring standards for professional audio equipment.
XLR:
1 = ground / shield
2 = +sig
3 = -sig
XLR female:
XLR male:
Summary of Contents for DPA153
Page 14: ...13 Block Diagram Chapter 4 ...
Page 16: ...15 Personal notes ...
