10
2)
Bridge mono Mode:
In bridged mono mode, the power of both Satellite output channels (Left & Right)
is merged to deliver double the power to one single 8 Ohm load. The mode
selection switch should be positioned in the Bridge position (Left position of the
switch).
The output of the signal source should only be connected with the Left channel
XLR input connector of the amplifier.
For more information about how the loudspeakers should be connected in bridge
mode, refer to the “Output Connections” section of this user manual.
3)
Parallel Mode:
In parallel mode (Right position of the switch), the amplifier is configured in a way
that only the signal applied to the XLR input connector of the Left channel will be
used, and will be amplified by both satellite and subwoofer output channels.
The output level of both channels can be individually controlled by means of the
rotary controls on front of the amplifier.
Summary of Contents for DPA153
Page 14: ...13 Block Diagram Chapter 4 ...
Page 16: ...15 Personal notes ...
