AUDAC AMP523MK2, User Manual

Page: 18 / 32

18
Mute button
Undernea th the input selection buttons is a MUTE button located, allowing complete
suppression of the output signal. When muted, this button will be indicated in red colour.
Toggling between mute and unmute is done by clicking this button again.
Volume control
The output volume can be set by moving the master fader (indicated by ‘Output’) up and
down. The volume can also be raised and lowered in steps of 1 dB using both buttons
on top and bottom of the fader.
Mixing faders for WLI and MIC/WMI
The left side of the main screen includes two mixing faders for mixing the microphone
input and the remote inputs. The mixing with WLI and MIC/WMI channels is 50% and
the level can be adjusted with both faders between 0 dB and -
∞
dB. This can be easily
done by sliding the faders up and down or by pressing the arrowed buttons on top and
bottom of the faders.
Two band tone control
The right side of the main screen includes two faders (‘Bass’ and ‘Treble’) for two-band
tone control adjustment. The adjustment for both treble and bass is possible in steps of
1 dB within a range of +14 dB and -14 dB.
Configuration menu
The top right corner indicates a setup button which redirects you to the general
configuration menu of the AMP523MK2.
Save
Use the ‘Save’ button in the top right corner when made any changes to the main screen
configuration. Default configuration will be re-loaded when rebooting the AMP523MK2,
if not saved.