AUDAC AMP523MK2, User Manual

Page: 16 / 32

16
Chapter 4
User interface & configuration
To get access to the control and configuration settings, the AMP523MK2 should be
connected to a computer or an Ethernet LAN network. For more information about
network connections and settings, see IP basics in chapter 6.
For using the remote flash control or Audac-Touch interface, the AMP523MK2 shall be
connected to an ethernet LAN network and accessed by its IP address. The standard
(factory default) IP address of the AMP523MK2 is 192.168.0.193, make sure this
address is within the IP range of the connected ethernet LAN network (subnetmask
255.255.255.0).
Any device (computer, laptop, ... ) with a web browser and flash plugin installed can be
used to control the web based user interface.
When application specific or total system control is required, the AMP523MK2 can
be controlled using the Audac Touch™ application. This application allows to custom
configure your control panel (Dashboard) according to project or user specific
requirements.
User interface & configuration
Start your default web browser and enter the IP address of the embedded web server of the
AMP523MK2 in the address bar. (The factory default IP address is http://192.168.0.193)
Login screen
First the login screen will be displayed.
A password should be entered to get access to the web interface. Once the correct
password is entered, click the “OK” button, and you will be redirected to the main screen
of the AMP523MK2. (The factory default password for the AMP523MK2 is ‘AMP523’.
NOTE
The passwords can be changed in the Configuration >> Password settings menu