AuCon AS47-G, Installation Manual

Page: 42 / 44

42
General information for the set-up:
The installation sites of the kit components and the measurements
of the vehicle hall have to be filled out on the attached layout
scheme and submitted to the relevant regulatory authority (in
Germany: The Federal Network Agency / Bundesnetzagentur),
together with the
application form.
On the scheme, please enter the distances between receiver and
repeater to the floor and hall doors.
To avoid interferences by feedbacks please note the following
when choosing the installation spot:

The repeater and receiver must be installed in a linear
distance of at least 10 m.

Repeater and receiver must not be installed in sight contact
from each other, i.e. they have to be separated by one or
more building shells (walls/roofs).

The receiver must not be installed in directly in front or
above of doors, gates, windows or roof windows,
ventilation shafts or other openings.
To avoid interferences by the surroundings outside the building
please note the following when choosing the installation spot and
using the repeater:

The repeater is intended for indoor installation and use
only!

The repeater should be installed as centrally in the building
as possible, in the middle of the hall.

The repeater must not be installed directly on outside walls,
in front of facades and hall gates and must be separated
from outside by at least one building shell.
The repeater must only be switched on during vehicle inspections
and with closed doors, otherwise the repeater must be switched off