Model :
ATZ HDMI-E100W
Description :
HDMI Wireless Extender 100M
pg. 5
Notes
:
- All brand names and trademarks are properties of their respective holders and are referred to here for descriptive purpose only. Photo attached is for reference only, it may be slightly varied in items of colour,
shape from the actual item delivered from time to time.
All specifications are subject to change without prior notice.
© Copyright ATZ
Panel key operation instructions:
1. Change Wireless Band: Select the switch on the front panel of TX, you can set the
working frequency range to 2.4g/5G.
2. Change Wireless channel: Press the “CHANNEL” key on the front panel of TX to
cyclic switch the multiple wireless channels. If the product works unsteadily or
pictures not fluid, you can try a different working channel.
3. Restore Factory Setting: To press the button for lasting three seconds, then the
HDMI Status Led Light will flash for three times and restart, it shows that Restore
Factory Set is successful.
The Factory Reset Button is located at the bottom of the Hole of the IR IN/OUT. It is
able to work under power on status. To use one long and narrow insulated stick (like
toothpick) to insert the hole end to press the button.
Web settings:
To prevent the interference caused by the same frequency device, the Wireless HDMI
Extender support to set up the working frequency, transmit channel and SSID by the
WEB. For safety, the user should change the SSDI and the password at the first log
in.
Please follow the below steps:
1. Connect 5V power supplies to the TX&RX, and let them be connected.
2. Turn on the WLAN of the mobile phone / PC
,
search and connect SSID,
HDMI Wireless, Enter the default password: 00000000.
3. Modify the IP address type of the mobile phone / PC to Auto. When you select
static type, you must be set the IP in 192.168.1.xxx address segment range, e.g.
192.168.1.100.
4. Open the browser and scan the QR code or enter “192.168.1.10”
in the address bar to enter the configuration page.. As shown below: