pg. 8
Notes
:
- All brand names and trademarks are properties of their respective holders and are referred to here for descriptive purpose only. Photo attached is for reference only, it may be slightly varied in items of colour, shape from the actual item delivered
from time to time.
All specifications are subject to change without prior notice.
© Copyright ATZ
Model :
ATZ HDBT-E150B-18
Description:
HDBaseT™ 1x8 Splitter HDMI 2.0b, HDR10+, 18G, support 4K@60hz
(150m) c/w 8x Receivers
ASCII Commands
The product also supports ASCII command control. Connect the RS-232 port of the product
to a PC with a 3-pin phoenix connector cable. Then, open a Serial Command tool on PC to
send ASCII commands to control the product. The ASCII command list about the product is
shown as below.
ASCII Commands
Serial port protocol. Baud rate: 115200, Data bits: 8bit, Stop bits:1, Check bit: 0
x - Parameter 1 y - Parameter 2
! - Delimiter
Command
Code
Function Description
Example
Feedback
Default Setting
Power
s power z!
Power on/off the
device,z=0~1 (z=0 power
off, z=1 power on)
s power 1!
Power on
System Initializing...
Initialization Finished! FW
version x.xx.xx
power on
r power!
Get current power state
r power!
power on/power off
s reboot!
Reboot the device
s reboot!
Reboot…
System Initializing...
Initialization Finished! FW
version x.xx.xx
System
Setup
help!
List all commands
help!
r type!
Get device model
r type!
HDC-SPB18H150
r status!
Get device current status
r status!
Get the unit all status:
power,
in/out connection, edid
mode
r fw version!
Get Firmware version
r fw version!
MCU BOOT: Vx.xx.xx MCU
APP: Vx.xx.xx
r link in!
Get the connection status
of the input port
r link in!
HDMI IN: connect
r link out y!
Get the connection status
of the y output port,
y=0~9(0=all, 1~8=HDBT
1~8, 9=loop out)
r link out 1!
hdmi loop out:
connect
hdbt output 1: connect
s reset!
Reset to factory defaults
s reset!
Reset to factory defaults
System Initializing...
Initialization Finished! FW
version x.xx.xx
Command
Code
Function Description
Example
Feedback
Default Setting
Output Setting
s hdmi
stream z!
Set hdmi loop output
stream on/off
z=0~1(0:disable,1:enable
)
s hdmi stream 1
!
Enable hdmi loop out
stream
Disable hdmi loop out
stream
enable
