2.2 Installation
The
IPSDMV22D1
camera is for use in surface or pendent mounting applications and the
mounting member must be capable of supporting loads of up to 3.5lb (1.6kg). (Pendent mounting
must use pendent mount accessory.)
The dome camera’s mounting bracket should be attached to a structural object, such as hard
wood, wall stud or ceiling rafter that supports the weight of the dome camera.
CAUTION: A silicone rubber sealant must be applied to seal the housing to secure
waterproofing.
2.2.1 Locking Dome Camera
A. Make screw holes on the ceiling using the supplied mounting Template Sheet (Figure A).
B. Fix the Mounting Bracket using Anchors(4x) and Mounting Screws(4x) to the ceiling (Figure B).
C. Hook up the Safety Lanyard to the Safety Lanyard Hook of the Mounting Bracket (Figure C).
D. Align the locking tap on the bracket and the locking slot on the base of the dome (Figure D).
E. Turn the dome to the counterclockwise about 10 degree to the locked position (Figure E).
3
Summary of Contents for IPSDMV22D1
Page 78: ...Figure Dimension 72 ...
Page 83: ...IPSDMV22D1 DOME CAMERA Rev B ...