Page 31
© 2001-2015 attocube systems AG. Product and company names listed are trademarks or trade names of their respective
companies. Any rights not expressly granted herein are reserved. ATTENTION: Specifications and technical data are subject
to change without notice.
IV.1.d.
Vacuum Feedthroughs
There are multi-pin cables used to connect the microscope to the
electronics rack. The black cables are labelled ‘1’ ,‘2’,’3’,’4’.
IV.2.
Fiber Connection
The optical read out system of the cantilever of the attoAFM I system requires
only one optical connection which will be described in this section.
For the optical connection plug the attoAFMI fiber into the laser port1 (or
port2) of the LDM1300. Please make sure to have the right orientation of the
fiber groove and tongue system (see Figure 14). Do not tighten too hard as
this might damage the optical connector.
Figure 14:
Connecting the FC/APC pigtail to a connector port. Be careful to obey the correct orientation of the
groove and the tongue.
