Page 17
© 2001-2015 attocube systems AG. Product and company names listed are trademarks or trade names of their respective
companies. Any rights not expressly granted herein are reserved. ATTENTION: Specifications and technical data are subject
to change without notice.
III.3.
(Dis-)Assembling the attoAFM I Module
This section will describe how to assemble and align the AFM module.
Figure 11:
The assembled attoAFM I module.
III.3.a.
Inserting (removing) the stack into (from) the microscope housing
The microscope stack is fixed to the housing bottom. By loosening
the two screws in the front and opening the three screws on the
left, right and back side
the whole bottom part including the
positioner stack may be pushed down and electrically disconnected
from the stick.
The stack and bottom plate may then be taken off towards the front
of the housing.
Open
bottom
screws
Loosen front
screws
