AT7016
User Manual
3
Do not place this instrument on an unstable or slanting surface . The dropping or turning over of
this instrument could result in electrical shock, injury or fire. If this instrument has been dropped or
its cover has been damaged, switch the power off, remove the power cord and call for repair.
Do not allow any foreign matter such as metal or inflammable substance to get into the instrument
via the air holes. The penetration of any foreign matter from the ventilation holes could result in fire,
electrical shock, or power failure.
Use this instrument with the rated AC power source. Use of this instrument with a voltage other
than specified could result in electrical shock, fire or power failure. The usable power voltage range
is marked on the rear panel.
Do not remove either the cover or panel.
Take sufficient care when measuring high voltages.
Do not modify this instrument.
Avoid use of damaged cables .
2. SPECIFICATIONS
2.1 VERTICAL SYSTEM
Sensitivity
5mV/DIV. ~5V/DIV
±
3%
Trimming Ratio
2.5:1
Rise Time
35ns
Bandwidth(-3dB)
DC:0~10MHz AC:10Hz~10MHz
Input Impedance
1M
Ω
±
3%,30 pF
±
5pF
Max. Input Voltage
400V pk
2.2 TRIGGER SYSTEM
Trigger Sensitivity
Int 1 div., Ext 0.3V
Ext. Trigger Input Impedance
1M
Ω
30pF
Ext. Trigger Max. Input Voltage
400Vpk
Trigger Sources
Int, Line, Ext
Trigger Mode
Norm, AUTO, TV
2.3 HORIZONTAL SYSTEM
Sweep Time
0.1S / DIV ~0.1
µ
S / DIV
±
3%
Trimming Ratio
2.5:1
2.4 X-Y MODE
Sensitivity
0.2V/DIV
〜
0.5V/DIV
Bandwidth(-3dB)
DC: 0~1MHz AC: 10Hz~1MHz
2.5 CALIBRATION SIGNAL
Waveform
Symmetric Square Wave
Range
05.V
±
2%
Frequency
1kHz
±
2%
2.6 CRT
Display Area
8
×
10DIV 1DIV=6mm
