Integrated Access Controller – Installation manual
All rights reserved. © AAT HOLDING S.A.
11
Duress User Settings
Wiegand Mode Setting
There are 10 groups Duress PIN/card available. When input Duress PIN/card, the door will open, at the
same time, the output alarm operates.
To set Duress PIN User
To add a PIN user
1 3 user ID number # PIN #
To delete a PIN user
As the same method of deleting common PIN user
(The ID number is any number between 2101~2110.)
To set Duress card user
To add a card user by read card
1 3 read card 1 # read card 2 … #
(The ID number is any number between 2101~2010.)
To add a card user by card number
1 3 user ID number # card … #
(The ID number is any number between 2101~2010.)
To delete a card user
As the same method of deleting common card user
To delete
All
Duress
users
Note that this is a
dangerous
option so
use with care
2 3 0000 #
Note:
① User ID number must be any 4digits between 2101 ~ 2110
① Duress PIN/card must be unique, should be distinguished from common PIN/card
(When the Duress PIN/card is the same with common PIN/card, they will become invalid in Duress, and
worked as common user function)
KZ-700-U/H
supports Wiegand 26~37, both input and output. It can be used as a reader or controller.
To Set Wiegand format:
9 26~37 # (Default setting: Wiegand 26)
Change Zone 2 to Door Bell
(When no need to operate a second door, Zone 2 can be set to operate the Door Bell. The wiring is connect-
ing the door bell to COM2 and NO2. Press #, the keypad will send the signal to the door bell.
Zone 2
84 0 # Factory default.
Door bell
84 1 #
To remove the alarm
To reset the Door Forced Open warning
Read valid card
or
Master Code #
To reset the Door Open Too Long warning
Close the door
or
Read valid card
or
Master Code #
