ATS TTV1EEM-3T Installation, Operation And Maintenance Manual Download Page 9

Page: 9 / 31

Con guration Settings

Step 1CS –

Press

and

buttons simultaneously for 5 seconds and release. If screen in Step 2CS does not

appear, the lock on the valve is activated. To unlock press

, NEXT, REGEN,

in sequence, then press

and

buttons simultaneously for 5 seconds and release.

Step 2CS –

Choose 1.0 for 1”, 1.25 for 1.25”, 1.5 for 1.5”, 2.0L for 2L, 2.0 for 2” valve ¹. Press NEXT to go

to Step 3CS. Press REGEN to exit Con guration Settings.
Note: When using the WS2 valve, if “2L” is set instead on “2.0” for valve type, when the valve is in
regeneration and the piston drives to the “Draw” cycle the piston will stall and generate a 1002 error code.
Clear error code by pressing “NEXT” and “REGEN” simultaneously until the valve resets, then re-program
to proper valve type setting.

Step 4CS –

Press the

buttons to select to regenerate immediately on 0 or at delayed time.

Immediately on 0 can only be selected if Volume (gallons) was selected in step 3CS and a meter must be
installed. Delay is the only option for the other Step 3CS selections. Press NEXT to go to Step 5CS. Press
REGEN to return to previous step.

Step 1CS

Step 2CS

Step 3CS –

Press the

buttons to select one of the following:

• If Volume (gallons) is selected the regeneration will occur after the speci c volume has been used or on the

day override (if selected) whichever comes rst.

• If 28/Volume (gallons) is selected the regeneration will occur on the day (1 through 28) selected in Installer

Display Settings. If a meter is not used the total ow and ow rate user displays and the volume display in
Diagnostics will be shown as 0.

• If 7/Volume (gallons) is selected the regeneration will occur on the selected day(s) of the week (see

instructions contained in Installer Display Settings). If a meter is not used the total ow and ow rate user
displays and the volume display in Diagnostics will be shown as 0.

• If 28 is selected the regeneration will occur on the day (1 through 28) selected in Installer Display Settings.

The total ow and ow rate user displays and the volume display in Diagnostics will not be shown even if a
meter is used.

• If 7 is selected the regeneration will occur on the selected day(s) of the week (see instructions contained in

Installer Display Settings). The total ow and ow rate user displays and the volume display in Diagnostics
will not be shown even if a meter is used.

Press NEXT to go to Step 4CS. Press REGEN to return to previous step.

Step 4CS

¹ When using the WS2 control valve, the circuit board software must have meter selection choices
of 2.0 and 2.0L. The WS2 valve must be set for the 2.0 meter selection during programming. If the
software version does not have both the 2.0 and 2.0L selections, consult your equipment supplier
for a replacement circuit board. When using the WS2L valve with older version software that does
not have both 2.0 and 2.0L selection choices, the valve must be set to 2.0 during programming. If a
WS2L valve is being used with newer version software that has both 2.0 and 2.0L selection choices,
the valve must be set to 2.0L during programming.

Step 3CS

Control Valve cont: