MAN - RTFO - REV: Org | G. Troubleshooting
16
G. Troubleshooting
G.1 Preface
Listed within this section are the most common troubleshooting errors that operators may encounter when using the
RTFO. Users may follow the steps provided to work through these basic errors.
WARNING: Any additional issues or system errors should be brought to the attention of the ATS
Service Department immediately. Please do not attempt to independently fix any other system
errors. Any additional errors fixed independent of technical support at Company could result in
damage to the equipment, or injury on the part of the operator.
WARNING: Place Main Power Switch in “OFF” position and disconnect power before removing
side cover to access electrical panel. ONLY open the side panel when explicitly instructed to.
Do not touch or alter anything within the side panel unless instructed to. Failure to adhere to this
warning could result in severe electrical shock, injury, or death.
G.2 Unit Will Not Turn On
1. Verify the system is plugged in to the correct power source and that the cord is secured to the power input on the
machine.
2. Verify the power switch on the front of the unit is in the ON position and the amber light is on (Sec. D.1, Fig. D.2).
3. Verify that the system’s circuit breaker is not tripped. Remove the side door panel and refer to (Sec. C.2, Fig. C.4)
for the circuit breaker location. If the breaker is in the OFF position instead of the ON position (Fig. G.1), switch it
back to the ON position (Fig. G.2).
Figure G.1: Circuit breaker in the
OFF position
Figure G.2: Circuit breaker in the
ON position
