ATS GDS-25, Installation, Operation And Maintenance Manual

Page: 16 / 20

GDS Series ©2016 16
Troubleshooting
PROBLEM CAUSE CORRECTION
U.V. lamp will not light Install a voltage regulator Check input voltage if below
or above 120 volts
Electrical cord disconnected
or outlet defective
Defective U.V. lamp
Defective lamp ballast
Loose open-circuit wire
Check, replace
Replace Lamp
Check output voltage
Replace ballast
Trace out and repair
Leak at quartz nipple Defective or cracked o-ring Replace o-ring
O-Ring not seated properly Replace o-ring
Cracked Quartz Sleeve Replace Quartz Sleeve
GDS ©2019 • www.aquat.com