Atrust m320, User Manual

Page: 27 / 50

Getting Your m320 Ready for Use
Getting Stations Ready for Use
19
3.1 Getting Stations Ready for Use
To get your m320-based LAN stations ready for use, you need to install the video driver, LAN station driver, and
MultiPoint Manager Add-in on your host server where Windows MultiPoint Server 2012 is installed:
Task Section Page
Installing the video driver, LAN station driver, and MultiPoint Manager Add-in 3.2 19
Initial setup - creating the bonding between the server and LAN stations 3.3 20
3.2 Installing Drivers and the Utility
To install the video driver, LAN station driver, and MultiPoint Manager Add-in on the host server for your m320-based
LAN stations, please do the following:
NOTE
• You will need an administrative account to perform the following tasks.
1. Switch your MultiPoint Server system to the Console mode.
2. Disconnect all station hubs if any.
3. Locate
Station_Video_Setup_SM_<version>.exe and Station_LAN_Setup_<version>.exe on your
host server and install both in sequence.
WARNING
• Ensure that the WDDM (Windows Display Driver Model) compatible driver is
installed for your host server graphics card before installing the video driver.
NOTE
• You should have got installation programs for drivers and the utility through the
Internet (FTP, email, or website) or a physical CD / DVD. Contact your dealer if
required installation programs are not available.
• If you’ve installed the video driver for your m300 / m302-based USB stations,
you don’t need to install it again.
• To update the video driver, LAN station driver, and MultiPoint Manager Add-in for
your m320-based LAN stations, please refer to section “3.4 Updating Drivers and the
Utility” on page 24.
4. After the installation is completed, switch your MultiPoint Server system to the Station mode.
5. Reconnect all station hubs.