![Atronic e2-motion Installation Manual Download Page 22](http://html1.mh-extra.com/html/atronic/e2-motion/e2-motion_installation-manual_3005143022.webp)
22
June 2008
e²-motion™ Installation Manual
MACHINE INSTALLATION
Check Commboard Settings
The commboard DIP switches and rotary switches
configure SAS address, APL address, progressive
mode and SAS (dual) channel allocation.
Use the DIP switch tables within manual "Software /
Basic Setup" for a particular software version (e.g.
C5.1.x) to check or alter the commboard settings.
Then connect to the online system components.
Apply Power
• Punch out one of the perforated knock-out plates
in order to provide access for the power cable (fi-
gure a).
• Mount the enclosed edge protection (figure b).
• Check that the machine mains cable has not been
damaged during transit.
• Check that the supply socket is in good condition
and not showing any signs of overheating or da-
mage.
• Connect the power cable to a
grounded
power out-
let, that is rated for min. 3A / 230V at 50 Hz or
6A / 115V at 60 Hz.
• Switch the machine on and check that the machi-
ne initializes. The LED's on the masterboard (they
indicate correct voltages) should all be lit. The po-
wer switch is located at the power supply left to
the hopper.
Note
: The power up cycle will take some minutes,
because the machine checks installed hardware
and security relevant circuits. To operate the ma-
chine while the maindoor is open, pull the maindoor
switch (set it to closed position).
M
ACHINE
I
NSTALLATION
Power Switch
Commboard
Logicbox
Cover
(a)
(b)
At this point the machine installation is finished. Proceed
with Basic Setup. (Initial Setup and Service Menu settings)
Please refer to the software manual for a particular software
version for details, e.g.
Manual HI Software (C5.x.x.x STD)