OPERATION INSTRUCTIONS
1.
Release the two front fasteners and open the lid.
2.
Remove hose and power cord from cover storage area.
3.
Remove the orange plug from the filter cartridge and store in unit.
4.
Slide one end of the hose into the filter cartridge.
5.
Attach appropriate accessories on the hose assembly.
6.
Plug the female end of the power cord into the receptacle on the vacuum.
7.
Close lid and latch securely.
8.
Plug the power cord into an appropriate outlet that is properly installed and grounded in
accordance with all local codes and ordinances.
9.
Turn on the power switch.
10.
These vacuums have a factory installed resettable Thermal Cutout (TCO) for added
operator and motor safety. If the unit gets too hot, the vacuum will shut down for
approx. 40 minutes. Turn the on/off switch to the off position, and turn back on in
approximately 40 minutes. Your hose may be clogged, or it may be time to install a new
filter.
11.
When vacuuming is complete, plug the filter with either the permanently attached filter
plug or the disposable orange plug when storing and not in use.
12.
The vacuum is equipped with a full filter indicator light underneath the switch/receptacle
and is labeled “Full Filter”. When the filter is nearing full capacity, the red light will turn
on.
13.
Filter Replacement: Requires No. 1 Philips Screwdriver and Small Adjustable Wrench.
Insert disposable filter plug. Open Lid. Remove metal filter retention bracket. Lift out
filter by putting fingers under each filter end tab and lift up and out. Dispose of filter.
Insert new filter. Reattach metal filter retention bracket.
FILTER CHANGE-OUT INSTRUCTIONS
(Requires Phillips Screwdriver and Small Adjustable Wrench)
1.
Release the two front latches and open the lid.
2.
Insert small orange disposable filter plug contaminated filter cartridge.
3.
Remove metal filter retention bracket.
4.
Put fingers under each end of filter under filter tabs.
5.
Lift up and out.
6.
Dispose of full filter in an appropriate manner compliant with all local, state, and federal
laws.
7.
Insert new filter.
8.
Reattach metal filter retention bracket.
9.
Close Lid and latch securely.