COLD CLIMATE INSTALLATION RECOMMENDATION:
When installing this unit against a Non-insulated exterior wall or chase, it is
mandatory that outer walls be insulated to conform to applicable insulation
codes.
ELECTRICAL CONNECTION
The unit comes standard with 6 feet (1.8M) three wire cord, exiting from the rear of the fireplace.
Plan the installation to avoid the use of an extension cord.
CLEANING TRIM
Clean the metal trim using a soft cloth, slightly dampened with citrus oil based product and buff
with a clean soft cloth. DO NOT use brass polish or household cleaners as these products will
damage the metal trim. Citrus oil based products can be obtained at supermarkets or hardware
stores.
MAINTENANCE
The motors used on the fan and the flame generator assembly are pre-lubricated for extended
bearing life and require no further lubrication. However, periodic cleaning/vacuuming of the fan/
heater unit is recommended. Make sure the unit is turn OFF and unplugged whenever you are
cleaning the heater of fireplace.
WARNING :
Make sure the power is turned off before proceeding. Any electrical
repairs or rewiring of this unit should be carried out by a licensed electrician in
accordance with national and locate codes. If repairing or replacing any electrical
component or wiring, the original wire routing, color coding and securing locations
must be followed.
WARNING :
Electric outlet wiring must comply with local building codes and
other applicable regulations to reduce risk of fire, electric shock and injury to
persons.
WARNING :
Do not use this fireplace if any part of it has been under water.
Immediately call a qualified service technician to inspect the fireplace and replace
any part of the electrical system.
WARNING :
Disconnect power before attempting any maintenance or cleaning to
reduce the risk of fire, electrical shock or personal injury.
WARNING :
During any service of this appliance, the power to the unit must be
turned off, Always remember to remove the electrical plug from the wall outlet.
4