Copyright© 2008. All Rights Reserved by ATP Electronics Inc.
10
Inserting Batteries
1. The following batteries are acceptable.
LR03 (size AAA) alkaline battery
L92 (size AAA) Lithium/Iron Disulfide battery
R03 (size AAA) Nickel-Metal Hydride battery
LR03 (size AAA) Oxyride battery
2. Carefully slide down the rear battery cover and insert 2 AAA batteries into the device in the orientation
displayed inside
.
3. Replace the battery cover.
4. Power ON the device by holding the power button for 3 seconds and the LED will flash Green for 2~3
seconds.
5. After usage, be sure to first turn OFF the power (Hold the power button for 3 seconds) before removing the
battery.
6. Playing time depends on the battery quality and type. Please refer to the comparison.
Comparing to using 2 rechargeable batteries ( 1.2V x 2 ), two Alkaline batteries works better because the
steady voltage ( 1.5V x 2), especially if you want to line a card reader.
L92 (size AAA)
Lithium/Iron Disulfide
battery
LR03 (size AAA)
Oxyride battery
LR03 (size AAA) alkaline
battery
R03 (size AAA)
Nickel-Metal Hydride
battery
Approx. 10.0 hours
Approx. 8.2 hours
Approx. 8.0 hours
Approx. 7.0 hours
WARNING
There is a danger of leakage or explosion if batteries are mishandled. Please be sure to observe the
following:
Insert batteries with the correct po/-.
Do not attempt to charge a dry battery.
Remove the batteries when not using the device for a prolonged period of time.
Do not break disrupt or switch off power when the device is transferring data to a memory card.
