14
/
22
Continue with step 6 when the parts have been removed.
Step 6
Mix the cleaner and lukewarm water. Depending upon the amount of mineral buildup, a
larger quantity of solution may be required. Use the ratio in the table below to mix enough solution
to thoroughly clean all parts.
water
Mixed with cleaner
Cleaner solution rate
2L
4 packs
Step 7
Use the cleaner/water mixture to clean all components. use a soft-bristle nylon brush,
sponge or cloth (NOT a wire brush) to carefully clean the parts. Soak parts for 5 minutes (15 - 20
minutes for heavily scaled parts). Rinse all components with clean water.
Step 8
While components are soaking, use the cleaner/water solution to clean all foodzone
surfaces of the ice machine and bin (or dispenser). Use a nylon brush or cloth to thoroughly clean
the following ice.
• Side walls • Base (area above water trough)
• Evaporator plastic parts - including top, bottom, and sides
• Bin or dispenser Rinse all areas thoroughly with clean water
SANITIZING PROCEDURE
Step 9
Mix a solution of sanitizer and lukewarm water
water
Mixed with sanitizer
Sanitizer solution rate
2L
4 packs
Step 10
Use the sanitizer/water solution to sanitize all removed components. Use a spray bottle to
liberally apply the solution to all surfaces of the removed parts or soak the removed parts in the
sanitizer/water solution.
Step 11
Use the sanitizer/water solution to sanitize all foodzone surfaces of the ice machine and
bin (or dispenser). Use a spray bottle to liberally apply the solution. When sanitizing, pay particular
attention to the following areas:
• Side walls
• Base (area above water trough)
• Evaporator plastic parts - including top, bottom and sides
• Bin or dispense,
Step 12
Wait 20 minutes. Do rinse these surfaces with drinking water after sanitizing.
Step 13
Replace all removed components.
Step 14
Reapply power to the ice machine. Toggle the switch on “clean” position again. Water will
flow through the water dump valve and down the drain. Wait until the water trough refills
(approximately 1 minute), then add the proper amount of ice machine sanitizer
Model
Amount of sanitizer(Kay 5)
YR140-AP-161
1 pack
YR280-AP-161
1 pack
YR450-AP-161
2 packs
YR800-AP-261
2 packs
Use a measuring cup, put in 1L water with the correspondent sanitizer packs with the models,
making the sanitizer solution to add the water trough.
Step 15
After when the sanitizing procedure finished, toggle the switch from clean to on position,
close and secure the front door.
