- 11 -
⚠︎
Warning! Use soap water or testing instrument to test whether piping joint leaks
or not before using, and forbid using an open flame to test!
⚠︎
After installing completely, you should check gas supply pressure. Use a pressure
gauge which is equipped with liquid (such as U-type pressure gauge, the minimum
value is 0.1mbar) or a digital pressure gauge to test. Steps are as following:
●
Remove top panel, and needle type pressure joint screw arbor (Fig.1), then slip
rubber tube of pressure gauge over needle type pressure joint;
●
Start the equipment in accordance with the instructions, measuring gas supply
pressure (dynamic pressure) in the work state;
●
Access to the equipment if measured data within
the limits of Table 1, otherwise, you will need to
adjust gas pressure regulating valve or contact
gas supplier to bargain;
Fig.1
●
Unplug pressure gauge after you accomplish pressure testing, then install needle
type pressure joint screw arbor.
Important: make sure screw up the needle valve
to prevent gas escape!
6.2
、
Debugging
It
’
s very important to debug the new stove. Through the comprehensive system
test of equipment, we can ensure function and safety performance of products.
Discovering any potential problems before use (such as equipment
’
s placement,
ventilation, operation, etc), can avoid costly losses.
