AC Power
Please use the attached power, note that power voltage and frequency are
the same as the marked voltage and frequency of device when connecting
power. Every device’s power should be connected separately, so that devi-
ce can be controlled individually.
Overhead Rigging
DMX-512 connection
Connection between laser lights and DMX must use the shied cable of diameter more than
0.5mm. Please use the attached 3 pin XLR plug/socket to connect the DMX output/input inter-
face. The connection between socket and cable as below( note the plug/socket’s 3 pin number
and position).
Note, XLR plug/socket’s 3pin can not be touched by inner hull, connection between pins is not allo-
wed. Except above connection, XLR plug/socket can not be connected with XLR control line. Device
receives international standard DMX512(1990) control signal.
When using standard DMX512 control signal, the last device’s output interface must be connected
to a DMX plug. This plug is putting a 120 ohm resistance between “canon” plug’s 2 pin and 3 pin.
Showing as below pic. Sticking this plug into the last device’s signal output interface, it will avoid
the interference during the process of signal transmission.
Atomic4Dj Laser Lithium 1500 RGB –
Cable(EU)
Cable(US)
Pin
Internatio-
nal
Brown
Black
Live
L
Liht blue
White
Neutral
N
Yellow/Gree
n
Green
Earth
