13
LED PUCK BATTERY CHANGE INSTRUCTION
STEP ONE:
Remove screws and back
cap from LED Puck using
Small
Phillips Screwdriver (not provided).
STEP TWO:
Remove CR2016 Lithium
Battery 3V from LED Puck.
STEP THREE:
Insert new CR2016 Lithium Battery 3V
into LED Puck.
STEP FOUR:
Install back cap and secure screws with Phillps Screwdriver
(not provided).
Positive “+”
on bottom
side
LED STRIKER BATTERY CHARGE INSTRUCTION
NOTE:
Make sure the on/off
switch on the back
cap properly aligns
and fits into its slot in
the LED puck during
reassembly
IF BATTERY HOLDER BRACKET
MOVES, RE-INSTALL IT TO LED
PUCK AS SHOWN IN DIAGRAM.
USB Port
LED INDICATOR WILL LIGHT-UP DURING CHARGING AND
WILL TURN OFF WHEN ITS FULLY CHARGED.
Helpful Hint:
The LED puck battery will last approximately 7 hours of continuous play. The puck battery is not
rechargeable. Be sure to turn the switch to the “OFF” position whe
n not in use to conserve your
battery life.
Helpful Hint:
The LED strikers each will require about 4 hours to fully charge up and will last approximately
7 hours of continuous play time. Be sure to turn the switch to the “OFF” position when not in use.
