Atomic COUPE & TRUCK, User Manual

Page: 61 / 67

■
Prepare a replacement light bulb
Check the wattage of the light bulb being replaced.
Front combination light Hi-beam light /Lo-
beam light 35W*2 / 35W*2
、
White
Front combination light position light 5W 、 White
Front combination light turning light 10W
、
amber
Side turning light 5W*2
、
amber
Rear combination light stop light /position
light Combined LED light
Rear combination light turning light 16W 、 amber
Rear fog light and reverse light
combination 21W/21W
、
Red/White
License plate light 3W*3 、 White
■
General rule
□
1 Lights must be off before replacing. Check the contact point to see whether it is oxidized.
□ 2 Replace the bad bulb with one of the same type and wattage rating.
□
3 The light beam direction must be checked to ensure acceptable light coverage after headlight bulb replaced.
□ 4 The inside surface of the headlight may have a thin layer of moisture in the early morning. This is normal and disipate
when lights are not. If moisture continues to stay built up, take the vehicle to a local dealer for service.
□
5 Do not use hands or dirty gloves to hold the bulb. Grease on your hand will affect the next replacement of light bulbs.
Clean a dirty lense with water and rubbing alcohol.
■
Adjustment of light beam
Adjustment of light beam ： The A adjustment is used to change the headlights projection up or down. The B adjustment is
used to change the light projection left and right.