atolla Bauihr T203, Quick Start Manual, Page: 10 / 83

Measurements
The Bauihr T203 Laser Distance Meter has a
measuring range of 164 ft(50 m) maximum. Use in
bright sunlight may decrease the range of the meter.
The reflective properties of the surface may also
decrease the range of the meter.
Single Distance Measurement
1.Switch on the laser instrument.
2.Direct the laser point at the target
3.Press the ON/READ button( ). And the measured
value is displayed.
Continuous Measurement, Max and Min
Measurement
1.Press and Hold ON/READ Button ( ) until the
continuous measurement active.
2.In continuous measurement mode, the measured
value is updated approximately every 0.5 seconds.
The corresponding minimum and maximum values
are displayed dynamically.
3.Press and Hold ON/READ Button ( ) again to stop
continuous measurement.
Adding/Subtracting Measurements
1.Press +/- Button ( ) to add the next measurement
to the previous one.
2.Press +/- Button ( ) again to subtract the next
second measurement (width).
4.Press ON/Measurement Button again to take the
third measurement (height).
5.The result of the volume calculation is displayed in
the summary line.
Indirect Measurements
Indirect measurements are used when a direct
measurement is not possible. Indirect measurements
are calculated from measurements of the hypotenuse
and one side of a right triangle (triangle with a 90
degree angle). Indirect measurements are less
accurate than direct measurements. For greatest
accuracy with Indirect Measurements, hold the
Bauihr T203 in the same position (only changing
angle) for all measurements.
Using Two Points
1.Press Area Button ( ) three times until the ( )
symbol appears in the display.
2.Aim the laser at the upper point ( 1 ) and trigger
the measurement. The measurement will be
displayed in the first line.
3.Keeping the instrument as perpendicular to the line
between the measurements as possible (with the
use of bubble level), Press ON/Measurement Button
again to measure the distance result of the
horizontal point ( 2 ). The measurement will be
displayed in the second line.
4.The result of the calculation is displayed in
summary line.