ato form Liftolet-Tilty, User Manual

Page: 16 / 32

Page 16/32 (23/21)
Assembly and adjustment
Commissioning
The following steps are required for restar-
ting the system when the system is started
up for the first time and in the event of a
fault.
Initial assembly / initialisation of the
drives:
• Press and hold the DOWN button until
the actuators move.
• Now press the button again until the
actuators have reached the lower end
position.
• Then press the UP button until the lifting
columns have moved up approx. 5 cm.
• Then press the DOWN button again
until the lifting columns have reached the
lower end position again and the control
unit switches off both drives.
• The sensors of the drives are now calib-
rated.
• The system is now initialised and can be
put into operation.
Attention
If the system cannot be put into opera-
tion after initialisation or after a fatal
error reset, contact the manufacturer.
Attention,
To avoid an unintended function, it is
pointed out that several keys must not
be pressed simultaneously.
The battery is only to be charged in dry
conditions.
Battery maintenance
The batteries must be replaced after four
years at the latest, depending on the inten-
sity of use, possibly even earlier. Frequent
and rapid discharging reduces the life of the
batteries. To achieve an optimal life span,
the batteries should be connected to the
mains as often as possible. The batteries
must be recharged every three months at
the latest, otherwise they will be damaged
due to self-discharge.
Attention
Batteries are excluded from the war-
ranty!
When in use never allow the battery to
discharge completely (observe charg-
ing indicator)! Ensure the battery is
recharged (overnight) when in use on a
daily basis. The battery cannot be over-
charged as the battery charger switches
automatically as soon as the battery is
fully charged.