2-11
4. turn the operation switch in standby position (StB).
5. to activate the scope, press and hold the pressure switch.
6. after disconnecting the remote control, replace the cap onto
the connector.
fIGURE 2-9 . REMOTE cONTROl
2.2.11. IR450 IllUMINATOR
Infra-red (Ir) Illuminators are common for night vision technolo-
gy. the Ir light greatly enhances the performance of your device,
while remaining almost totally invisible to the naked eye. Staying
in the dark, switch on your night vision device. If the visibility is
low, you may use atn Ir450 to improve the situation. Still, you
should remember that the Ir illuminator is just a source of infrared
light so the greater is the chosen range of observation, the lesser
its brightness becomes.
Ir450 Infrared Illuminator can be mounted with Mars onto the
pica-tinny rail.
Ir450 Installation:
1. loosen the fixing nut of Ir450.
2. Install the Ir450 onto the picatinny rail.
3. tighten the fixing nut of Ir450 tightly.
the atn Ir450 is powered with one Cr123a lithium battery. to
install the battery unscrew the cap of the battery housing and in-
sert the battery following the polarity arrows marked on the hous-
ing. put the cap in place.
the Ir-450 illuminator has a control panel with two buttons. to
switch the IR illuminator on/off press “+” and “-” buttons simultane
-
ously. When the Ir illuminator is switched on you can see the green
velCro tape
reMote Control
