Page 6
Installation, Operation & Maintenance Guide - FC-400 FM
East Coast: 203-335-3700
West Coast: 480-629-4784
CAG-04-19-001-USA
www.AtmosAir.com
2.2 Electrical Installation
3. Operation
• AtmosAir FC400 series systems require approximately 4.0 watts. The FC-400 series can be wired directly to
single-phase blower circuits.
• Follow proper electrical procedures, guidelines, and codes for providing power to the systems, including
requirements for conduit, sufficient ampacity, phase balancing, etc. Electrical installation should be performed
by a qualified electrician.
• Field-install a power plug outlet or junction box within 6 feet (1.8m) of the unit(s).
• Each FC-400 series unit is typically shipped with a 8-foot (2.4m) power cord with a field install pair of wire hot/
neutral connector on one end and a quick disconnect plug on the other end. FC-400FM has a polarized quick
disconnect on the unit. Each unit is shipped with 2 wiring options per country-specific requirements:
1.
2 conductor, field wire connection (No Ground)
2.
NEMA 5-15 2-prong plug adapter
Once the system is properly installed and
ALL PERSONNEL ARE CLEAR
of the high voltage tubes, the system can
be turned on:
1.
Ensure the ionization power knob is turned all the to the appropriate quadrant. From low to high clockwise.
2.
Plug the power cord into the plug receptacle on the FC-400 ionization system. (The FC-400 Series units are
shipped with a quick disconnect spade terminals. The male and female terminals are specifically arranged
so that the polarity can only be connected the correct way. Eliminating the risk of damaging the unit by
accidentally reversing the polarity.
Caution!
A non-functioning LED light may improperly indicate that the system is not functioning. Be sure to disconnect
from the main power before performing maintenance or troubleshooting the system.
provided to locate the cut-out hole, then cut out with a 2.5” (6.35cm) Hole Saw and mark the locations of the
mounting holes for the FC-400FM. Mark the drill holes for the self tapping screws to mount the FC-400 FM to
the Duct Wall.
6.
Affix the unit securely in the duct using self-tapping screws . Do not over-tighten, this may strip the screw-hole.
The unit is self-sealing to the duct so no further sealing is needed.
7.
Units should be installed to allow easy access for maintenance. Install units so that the power adjustment knob,
fuse and status light are easily accessible, variable and visible.
2.1 Mechanical Installation Continued...
