Atmel SAM4S Series, Preliminary Data Sheet

Page: 917 / 1163

917
11100B–ATARM–31-Jul-12
SAM4S Series [Preliminary]
By using buffer registers PWM_OSSUPD and PWM_OSCUPD, the output selection of PWM
outputs is done synchronously to the channel counter, at the beginning of the next PWM period.
By using registers PWM_OSS and PWM_OSC, the output selection of PWM outputs is done
asynchronously to the channel counter, as soon as the register is written.
The value of the current output selection can be read in PWM_OS.
While overriding PWM outputs, the channel counters continue to run, only the PWM outputs are
forced to user defined values.
37.6.2.6 Fault Protection
6 inputs provide fault protection which can force any of the PWM output pair to a programmable
value. This mechanism has priority over output overriding.
Figure 37-9. Fault Protection
The polarity level of the fault inputs is configured by the FPOL field in the “PWM Fault Mode
Register” (PWM_FMR). For fault inputs coming from internal peripherals such as ADC, Timer
Counter, to name but a few, the polarity level must be FPOL = 1. For fault inputs coming from
external GPIO pins the polarity level depends on the user's implementation.
The configuration of the Fault Activation Mode (FMOD bit in PWMC_FMR) depends on the
peripheral generating the fault. If the corresponding peripheral does not have “Fault Clear” man-
agement, then the FMOD configuration to use must be FMOD = 1, to avoid spurious fault
detection. Check the corresponding peripheral documentation for details on handling fault
generation.
The fault inputs can be glitch filtered or not in function of the FFIL field in the PWM_FMR regis-
ter. When the filter is activated, glitches on fault inputs with a width inferior to the PWM master
clock (MCK) period are rejected.
A fault becomes active as soon as its corresponding fault input has a transition to the pro-
grammed polarity level. If the corresponding bit FMOD is set to 0 in the PWM_FMR register, the
fault remains active as long as the fault input is at this polarity level. If the corresponding FMOD
bit is set to 1, the fault remains active until the fault input is not at this polarity level anymore and
until it is cleared by writing the corresponding bit FCLR in the
“PWM Fault Clear Register”
(PWM_FSCR). By reading the “PWM Fault Status Register” (PWM_FSR), the user can read the
FIV0
fault input 0
Fault protection
on PWM
channel x
Glitch
Filter
FFIL0
from fault 0
from fault y
1
0
=
FPOL0 FMOD0
1
0
Fault 0 Status
FS0
FIV1
Glitch
Filter
FFIL1
1
0
=
FPOL1
SET
CLR
FMOD1
1
0
OUT
Fault 1 Status
FS1
fault input 1
from fault 1
1
0
0
1
From Output
Override
OOHx
OOLx
From Output
Override
FPVHx
FPVLx
PWMHx
PWMLx
fault input y
FMOD1
SET
CLR
Write FCLR0 at 1
OUT
FMOD0
Write FCLR1 at 1
SYNCx
1
0
FPEx[0]
FPE0[0]
SYNCx
1
0
FPEx[1]
FPE0[1]