Atmel AVR364, User Manual

Page: 6 / 15

6
AVR364
8377B-AVR-11/11
4 Connectors
The Atmel MEGA-1284P Xplained kit has five 10-pin, 100mil headers. Two headers
have a fixed communication interface (J1 and J4). One header has analog
functionality (J2), and the last header (J3) has general purpose digital I/O.
The 90° angled header is thdebugging header.
For the location of the respective headers, refer to Figure 3-1 .
4.1 Programming headers
The programming/debugging tool to the JTAG pin header. The pin header has a standard
JTAG programmer pin-out (refer to online help in the
), enabling
tools like thedirectly to the header.
The grey, female, 10-pin header on th must be used when
connecting to the kit. A scoring in the board is made to fit the orientation tab on
the header.
A standoff adapter (nr. 1) is needed when using th
Pin 1 on the JTAG header is at the top right corner. This is rotated 180°
compared to the other headers (J1, J2, J3, and J4).
Table 4-1. MEGA-1284P Xplained programming and debugging interface – JTAG.
Pin JTAG
(1)
1 TCK
2 GND
3 TDO
4 VCC
5 TMS
6 nSRST
7 -
8 -
9 TDI
10 GND
Note: 1. Standard pin-ou and other Atmel programming tools
The loader is evoked by shorting the two holes marked
BOOTLOADER BOARD
CONTROLLER on the bottom side of the board before applying power to the board.
The two holes have 100mil spacing, enabling the user to solder in a two-pin header
and use a jumper to easily enter the boot loader. Programming is performed through
the boot loader programmer targ.
Alternatively, the programming tool, such as the
, to the 10 holes marked JTAG
BOARD CONTROLLER on the bottom side of the board. The holes have 100mil
spacing, letting the user solder in a 10-pin header to program the board controller.