9
Programming the hex file in SAMR30-XPRO (If required):
Board was already programmed with certification software/performance analyzer. In case if required to flash the
program file, follow the below steps.
If programming the SAMR30-Xpro board for the first time, follow the section 7(SAMR30 part pack installation) before
start programming.
6.1. Connect the SAMR30 XPRO board to the PC via EDBG micro USB connector.
* PC should have the Atmel Studio 7 installed in it
6.2. In Atmel studio,select Tools
Device Programming
6.3. In Device Programming dialog box, select the edbg serial number and ensure the Device is “ATSAMR30G18A”
and select ‘SWD’ as Interface. Then click “Apply”
