This message is shown when the sensor battery has a voltage below 2.2V and needs to be replaced.
!!!!!!!!!!!!!!!!!!!!!!
Sensor error:
Low battery voltage!
!!!!!!!!!!!!!!!!!!!!!!
This message is shown when a wrong acknowledge telegram was received.
::::::::::::::::::::::
RF telegram error:
Wrong ACK telegram!
::::::::::::::::::::::
This message is shown when no RF acknowledge telegram was received.
::::::::::::::::::::::
RF channel error:
No RF ACK telegram!
::::::::::::::::::::::
This message is shown when the RF acknowledgement from the base station could not be send.
::::::::::::::::::::::
RF channel error:
RF TX telegram err!
::::::::::::::::::::::
This message is shown when the RF receiver is detecting a signal on another RF channel (this must be
enabled in the EEPROM configuration of the receiver).
::::::::::::::::::::::
RF channel error:
Wrong RF telegram!
::::::::::::::::::::::
4.3.
Software Development
Atmel
®
Studio 6 or 7 is required for base station software development and can be downloaded from the
Atmel website [4]. In addition, the tool pack [10] with software and documentation is required. IAR
Embedded Workbench for AVR [5] and the JTAGICE3 AVR
®
debug tool [4] are required for remote sensor
software development.
4.3.1.
Xplained PRO SAMD20 Base Station
For the software development of the base station the project file is located in the extracted folder in the
subdirectory
..\Software\base\SAMD20_XplainedPRO_SW Atmel Studio 6 or 7 project directory
After the installation of Atmel
®
Studio 6 or 7 the USB driver will be installed automatically when
connecting the Xplained Pro SAMD20 board for the first time. When opening Atmel Studio you will see
the landing page of this kit were you can obtain the documentation and sample projects. The OLED
display will show the welcome screen and wait for a RF telegram from the remote sensor. After attaching
the battery to the remote sensor the RF telegram will be immediately transmitted and is repeated every
2 seconds with an update on the temperature, RF telegram interval and RSSI signal strength parameter
(if the optional real time clock is installed on the sensor otherwise the button S2 on the remote sensor can
be pressed to transmit a RF telegram). You can also view the received information when opening a PC
terminal application and selecting the COM port of the XplainedPRO board with a baudrate of 38.4kBaud,
8 data bit, 1 stop bit no parity and no handshake selected.
Atmel User Guide for the Evaluation Kit ATA8510-EK1 [APPLICATION NOTE]
Atmel-9343D-ATAN0046_Application Note-09/2016
16
