AT91EB40A Evaluation Board User Guide
3-3
2635C–ATARM–13-May-05
4.
Put JP1 in USER position and press the reset button. The application down-
loaded starts.
Note:
1. For the Serial B port, use a female/female straight serial cable.
3.5
Angel Monitor
The Angel Monitor is located in the Flash from 0x01006000 up to 0x01011FFF. The
boot program starts it if no button is pressed at reset.
When Angel starts, it recopies itself in internal SRAM in order to run faster. The internal
SRAM used by Angel is from 0x00020000 to 0x0003FFFF, i.e., the highest half part of
the internal SRAM.
The Angel on the AT91EB40A Evaluation Board can be upgraded regardless of the ver-
sion programmed on it.
Note that if the debugger is started through ICE while the Angel monitor is on, the
Advanced Interrupt Controller (AIC) and the USART channel are enabled.
Summary of Contents for AT91EB40A
