2-2
Demonstration Kit User Guide
5183A–ZIGB–12/07/06
9.
Randomly
change the functionality of the RCBs in the Configure screen by
first selecting the desired unit by pressing the joystick up or down, then press
SW2 to change the function to either an LED unit or one of the three switch
units.
10. Press SW1 to return to Network Monitor mode and observe the new function
of the units.
11. When finished, return all power switches to the OFF position.
12. Please consult Table 7-1 if problems are encountered.
13. RCBs must contain a valid MAC address. If the MAC address was reset to
FF-FF-FF-FF-FF-FF-FF-FF you must reprogram the MAC address as out-
lined in section 6.2.3..
Summary of Contents for AT86RF230
