5
atlona.com
Toll free: 1-877-536-3976
Local: 1-408-962-0515
EDID
POWER
ENTER
FCN
CANCEL
INFO
1
1
HDMI IN
HDBaseT OUT
2
3
4
1
2
3
4
5
6
7
8
2
3
4
5
6
7
8
AT-UHD-CLSO-840
LAN
RS-232
AUDIO OUT
HDBaseT IN
HDMI OUT
AUDIO IN
1
R
L
R
L
R
L
R
L
R
L
R
L
R
L
R
L
2
3
4
1
2
3
4
RX TX
PWR: 100-240VAC 50/60Hz
OFF
ON
+
+ -
-
+
+ -
-
+
+ -
-
+
+ -
-
+
+ -
-
+
+ -
-
+
+ -
-
+
+ -
-
Back Panel
1. HDMI Input - Connect HDMI sources to these ports
e.g.
DVD players, Blu-ray players, computers, game consoles, etc
2. HDBaseT Inputs - Connect compatible PoE transmitters to these ports
e.g.
AT-UHD-EX-100CE-TX
3. HDMI outputs - Connect to local displays, AVRs, or transmitters
e.g.
AT-UHD-EX-100CE-KIT
4. HDBaseT Outputs - Connect to compatible PoE receivers
e.g.
AT-UHD-EX-100CE-RX or AT-HDVS-200-RX for scaling
5. LAN port - Connect to a network switch for TCP/IP, webGUI, and AMS control, as well as
firmware updating
6. RS-232 port - Control the matrix or send zone commands through HDBaseT ports
7. Audio IN - Connect analog audio sources here
- Audio inputs follow the corresponding HDBaseT outputs
e.g.
Audio IN 1 follows HDBaseT OUT 1
8. Audio out - Captive screw analog audio outs for use with a sound system or multi-channel
zone amplifier
- Audio outputs can be mirrored to any output or paired to any analog input.
9. Internal power supply - Connect included IEC C13 power cable from here to a power outlet.
1
2
4
5
6
3
7
8
9
To rack mount the UHD-CLSO-840
unit: use the rack mount ears, the 6
screws from the sides of the UHD-
CLSO-840, and 4 rack screws.
To affix the rack mount ears,
remove the three screws on each
side of the UHD-CLSO-840 and affix
the rack ears to the UHD-CLSO-840
(as shown in the picture to the left).
Place the UHD-CLSO-840 in the
rack, lining the holes in the rack
ears with the holes in the rack.
Once placed, use the rack screws to
keep the unit in place. (as shown in
the picture to the left).
Note:
Increase the air flow as needed
to maintain the recommended
temperature inside the rack.
Note:
Do not exceed maximum weight
loads for the rack. Install heavier
equipment in the lower part of
the rack for stability.
POWER
ENTER
CANCEL
INFO
EDID
FNC
5
6
7
1
2
3
8
4
POWER
ENTER
CANCEL
INFO
EDID
FNC
5
6
7
1
2
3
8
4
Rack Mounting
