Atlona AT-HDVS-200-RX, Manual

Page: 35 / 62

AT-HDVS-200-RX 35
Commands
Command Description
Aspect Sets the aspect ratio of the output signal
Bass Increases / decreases the amount of bass on the output
Blink Enables or disables blinking of the DN button on the front panel
Broadcast Enables / disables broadcast mode
BRT Sets the picture brightness
CSpara Sets the baud rate, data bits, stop bits, and parity for the RS-232 2 port
CTRST Sets the picture contrast
HDBTRS232 Sets the baud rate, data bits, parity bit, and stop bits for the HDBaseT IN port.
HDCPSet Sets the HDCP reporting mode for the HDMI input on the transmitter
HDMIAUD Enables / disables audio on the HDMI output
help Displays the list of available commands
HUE Sets the picture hue
HZoom Sets the horizonal overscan setting for the output image
Input Sets the active input
IPAddUser Adds a user for Telnet control
IPCFG Displays the current network settings for the AT-HDVS-200-RX
IPDelUser Deletes the specified Telnet user
IPDHCP Enables / disables DHCP mode on the AT-HDVS-200-RX
IPLogin Enables / disables login credentials when starting a Telnet session
IPPort Sets the Telnet listening port for the AT-HDVS-200-RX
IPStatic Sets the static IP address, subnet mask, and gateway for the AT-HDVS-200-RX
IPTimeout Specifies the time interval of inactivity before the Telnet session is closed
KitMode Displays the model information and the IP address of the transmitter
Mreset Resets the AT-HDVS-200-RX to factory-default settings
PictureRst Resets all picture settings
PrefTimg Sets the preferred HDMI input timing
IMPORTANT: Each command is terminated with a carriage-return (0x0d) and the feedback is
terminated with a carriage-return and line-feed (0x0a).
The following tables provide an alphabetical list of commands available on the AT-HDVS-200-RX. All commands
are case-sensitive and must be entered as documented. If the command fails or is entered incorrectly, then the
feedback is “Command FAILED”.