AT-GAIN-120
20
Basic Operation
Power Modes
The following section discusses the power mode features which have been integrated into the AT-GAIN-120.
Power modes are located under the
Control
tab within the web GUI.
Click the
OFF
option to power-off the AT-GAIN-120. When powered-off, audio output is disabled but both the LAN
port and
INPUT
port (AT-GAIN-NET audio card, only) will remain active. To power-on the AT-GAIN-120, after it has
been powered-off, any one of the following methods may be used:
•
Press and hold the
IP RESET
button for a minimum of 3 seconds, but not more than 5 seconds.
•
Pull the
TRIGGER
port from low to high.
Unit Trigger
must be enabled for this to function.
• Set
Power
to the
ON
setting, in the web GUI.
•
Route Dante / AES67 audio.
1.
Open the desired web browser and enter the IP address of the AT-GAIN-120.
2.
Log in, using the required credentials. The factory-default username and password are listed below:
Username:
admin
Password:
Atlona
3. Click the
Control
tab, located on the side menu bar. The
Control Settings
section will be displayed.
Powering On or Off
Enabling this mode will automatically power-down the AT-GAIN-120 if no audio input signal is present on either the
INPUT
port (AT-GAIN-NET audio card, only) or the
ANALOG IN
port, after the specified time interval. When the AT-
GAIN-120 enters Auto Power Down mode, the Power option will be set to
OFF
and the front-panel LED indicators will
turn off. In Auto Power Down mode, power consumption is limited to 2.2 W. By default this feature is enabled.
Note that when this mode is enabled, the AT-GAIN-120 only monitors the existence of an audio input signal, not the
physical audio connection. Refer to the next page for instructions.
Auto
Power Down mode
