AtlasSound.com
– 4 –
Specifications are subject to change without notice.
Owner’s Manual
PA1001G Power Amplifier
1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A.
Telephone: 800.876.3333 • Fax: 800.765.3435
When the deVice is in use
• To prevent electric shock, do not remove the product cover as there are high voltage components inside.
Refer all servicing to Atlas Sound.
• Should any of the following irregularities occur during use, immediately switch off the power, disconnect the power
cord from the AC outlet and contact Atlas Sound. Do not to attempt to continue operation with the product as this
may cause fire or electric shock:
• Smoke or strange smell coming from the unit.
• If the product falls or the case is damaged.
• If water or any metallic objects falls into the product.
• If the power supply cord is damaged in any way.
• If the unit is malfunctioning.
• Do not insert or drop metallic objects or flammable materials into the ventilation holes of the product's cover, as this
may result in electric shock or fire.
• Do not place any containers with liquid or metallic objects on the top of the product. If any liquid spills into the unit,
fire or electric shock may result.
• Never operate this product or touch the power supply cord during an electrical storm, electric shock may result.
• Never exceed the wattage on the product when connecting equipment. Fire and/or property damage may result.
• Operate the product only with the voltage specified on the unit. Fire and/or electric shock may result if a higher
voltage is used.
• Do not modify, kink, or cut the power cord. Do not place the power cord in close proximity to heaters and do not place
heavy objects on the power cord, including the product itself, doing so may result in fire or electrical shock.
• Replace the protective cover over the speaker terminals after installation. Do not touch the 70V speaker terminals as
electric shock may result.
• Ensure that the safety ground terminal is connected to a proper ground. Never connect the ground to a gas pipe as a
catastrophic disaster may result.
• Be sure the installation of the product is stable, avoid slanted surfaces as the product may fall and cause injury or
property damage.
When installing the Product
• Plugging in or unplugging the power cord with wet hands may result in electric shock.
• Never move the unit with the power cord plugged into the wall, as damage to the power cord may result.
When unplugging the cord from the wall, grasp the plug, NOT the cord.
• Never install this product in humid or dusty locations, nor in direct sunlight, near sources of heat, or in areas where
sooty smoke or steam are present. Fire and electric shock may result.
• Keep all sides of the unit at least 3
1
⁄
2
" away from objects that may obstruct air flow to prevent the unit's internal
temperature rise.
WArninG
cAution